How to hook up manual boost controller honda

 · just like the title says. i have a manual boost controller. same as the picture below. i cant seem to find a strait foreward diagram on how to install it. i am using a external wastegate and i have a vacuum manifold. anyone? i think i just hook the bottom line to the top of the wastegate, and.  · ok i got a manual boost controller for my teg but t came with ABSOLUTELY NO www.doorway.ru know of a site i kinda know how it goes but i wanna make sure, so i don't f*** anything up Thanks guys I use this to help people all the time trying to hook these up. Diagrams are way easier than to read all that crap. www.doorway.ru is an. Connect the pressure source to the 'bottom' of the wastegate (were the pressure will act to open the wastegate). Tee the pressure source and connect via the solenoid to the 'top' of the wastegate. Try to place the solenoid close to the wastegate and keep the tubing reasonable short (but do not place the solenoid where it will get hot).

How to Install a Boost Controller (standard turbo, non-VNT) Locate a source of turbo boost pressure for the input side of the MBC (manual boost controller). This can be a port on the turbo outlet or the intake manifold. Connect a hose to this boost source and use a hose clamp or cable tie to hold it in place. Boost controllers typically come with approximately 3 feet of vacuum line that you can cut into 2 pieces of desired lengths. The first piece will connect from the boost barb on the controller to your boost source. The second piece will connect from the wastegate barb on the controller to the wastegate vacuum port. TEST AND TUNE THE DOME PRESSURE PID CONTROLLER 1. Power up the ECU. 2. Go online with the Holley PC software. 3. Switch to the data monitor window that has boost related variables. 4. As you cycle the T-Brake/Launch switch, you should see the Target Boost change. When the switch is on, the Target Boost should be the Launch Target value.

just like the title says. i have a manual boost controller. same as the picture below. i cant seem to find a strait foreward diagram on how to install it. i am using a external wastegate and i have a vacuum manifold. anyone? i think i just hook the bottom line to the top of the wastegate, and. And the controller certainly shouldnt be before the BOV, otherwise it will be "controlling" the BOV. The BOV needs a single vaccume source going from it to the intake manifold. Do it like this: I/M -- BOV. I/M -- Boost gauge. Pipe Before T/B -- Boost controller --Wastgate. If the controllers on the same hose as anything else you have done it wrong. Install the Boost Tee in the wastegate pressure line with the wastegate arrow pointing towards the bottom port on the wastegate. Secure all silicone hose ends with hose clamps. Mount your boost controller bracket onto the vehicle, then attach the boost controller onto the bracket with the supplied screws.